€ 149,99
Brez DDV: € 123,96
Opis artikla
The MCOHome fan coil thermostat is a Z-Wave compatible device for indoor temperature control. It is mainly used with a 2-pipe fan coil system. It measures the ambient temperature and knows the local time, so it can automatically control the fan speed according to the temperature difference. This thermostat can be included and operated in a Z-Wave network with other Z-Wave certified devices from any other manufacturer. Each Z-Wave powered module works like a wireless repeater with other modules, to ensure total coverage of your home.
FUNCTIONS:
- Thermostat for 2-pipe fan coil unit Intelligent on / off control of a 3-speed fan or electric valve
- Ventilation, heating, cooling mode LCD display
- Display of time and temperature
- Temperature Calibration
- Non-volatile memory to keep the operating state after a power failure
- Z-Wave Plus Compatible
- Glass finish, modern design Capacitive Touch Buttons
TECHNICAL CHARACTERISTICS:
- Module Type: Z-Wave Receiver
- Material: Tempered glass and plastic (PC Alloy)
- Power supply: 230VAC, 50 / 60HZ
- Maximum load: 3A
- Power consumption: <1W
- Frequency: 868.42 Mhz
- Range: up to 30 m
- Temperature Sensor: NTC 15K
- Display accuracy: 0.1 ° C
- Operating Temperature Range: 0-55 ° C
- Temperature setting: 5-35 ° C
- Dimensions: 86 x 86 x 42 mm
- Installation: Wall (vertical), square box 86 x 86 mm
Karakteristike
| Glavni krmilnik Združljivost | |
|---|---|
| eeDomus+ | Compatible but fan coil speed management |
| Fibaro Home Center 2 v4.160 | Not compatible |
| Fibaro Home Center Lite v.4.160 | Not compatible |
| Vera Edge / Plus / Secure | Not compatible |
| Zipabox/Zipaminicro/ZipaTile | Not compatible |
| Piper / Piper NV (v.1.7.1) | Not compatible |
| Indigo | Not Tested |
| jeedom | Not Tested |
| Z-Wave.me / Z-Way / PoPP Hub v 3.2.1 | Not Compatible |
| Domoticz | Not Tested |
| OpenHAB | Not Tested |
| Tech Data | |
| IP Rating | IP20 |
| Power Supply | 230 V AC |
| Attachable Loads | 3A |
| Explorer Frames - NWI Support | |
| SDK | |
| App Version | |
| Device Type | |
| Z-Wave Alliance Product Link | |
| Procedures | |
| Inclusion | Under the shutdown state, press & hold to enter interface for inclusion or exclusion of Z-Wave network. Before device included into network, “- - -” will display on the screen. Then press once, device will enter learning mode to get a node ID. If inclusion is success, a node ID will display on the screen in a few seconds. A node ID can always inform us whether the device is in the network or not. |
| Exclusion | Under the shutdown state, press & hold to enter interface for inclusion or exclusion of Z-Wave network. Before device included into network, “- - -” will display on the screen. Then press once, device will enter learning mode to get a node ID. If inclusion is success, a node ID will display on the screen in a few seconds. A node ID can always inform us whether the device is in the network or not. |
| Factory Reset | |
