€ 89,99
Brez DDV: € 74,37
Opis artikla
Z-Uno (included) is very powerful but requires some knowledge of schematics and programming.
To help users and installers to work with Z-Uno the Z-Uno Shield was created.
Z-Uno Shield is a multifunctional DIN-rail smart home device based on Z-Uno. It implements most useful features of Z-Uno and requires no soldering and no programming.
No soldering required!
Z-Uno Shield is very easy to wire. It allows to connect many smart home actors and sensors out of the box:
- One 0-10 V analog output
- control industrial dimmers Up to four PWM or switch outputs (up to 5 A per channel)
- control contactors, switches, halogen bulbs or LED strips Up to eight digital 0/3 V inputs or outputs
- connect various low voltage digital senors and actors Up to four digital 0/3, 0/5 or 0/12 V digital or analog inputs
- connect industrial 10 V sensors or any Arduino-compatible sensor RS485 or UART
- for industial meters OneWire
- for DS18B20 or other sensors
For those who still want to solder something there is a bread board for your additional components.
No programming required!
The Z-Uno Shield Configurator will not only help you to wire your Z-Uno Shield correctly, but will also write the Z-Uno sketch for you. Most popular cases are covered by this tool. You can still modify the generated code or write your own sketch.
Z-Uno Shield Configurator allows you to create:
- Dimmers and Blinds Switches
- Sirens
- Valve controls
- Door locks Sensors
- Thermostats
Scope of delivery:
- Z-Uno Z-Uno Shield
- RAil DIN housing + accessoires
Karakteristike
| Glavni krmilnik Združljivost | |
|---|---|
| eeDomus+ | Full Compatible |
| Fibaro Home Center 2 v4.160 | Not Tested |
| Fibaro Home Center Lite v.4.160 | Not Tested |
| Vera Edge / Plus / Secure | Not Tested |
| Zipabox/Zipaminicro/ZipaTile | Not Tested |
| Piper / Piper NV (v.1.7.1) | Not tested |
| Indigo | Not tested |
| jeedom | Full Compatible |
| Z-Wave.me / Z-Way / PoPP Hub v 3.2.1 | Full Compatible |
| Domoticz | Not tested |
| OpenHAB | Not tested |
| ZiHome | Not tested |
| Tech Data | |
| Power Supply | USB 5 V, external 5V or 3 V, external 7-18 V or battery (via MU-2F connector, included) |
| Attachable Loads | Defined by user: http://z-uno.z-wave.me/examples/Certified10Channels/ |
| Explorer Frames - NWI Support | Yes |
| SDK | 6.51.06 |
| Device Type | Always On Slave |
| Z-Wave Alliance Product Link | http://products.z-wavealliance.org/products/1825 |
| Procedures | |
| Inclusion | Press Service button three times |
| Exclusion | Press Service button three times |
| Factory Reset | Hold Service button for five seconds, then press Service button three times. Use this procedure only if your controller is missing or inoperable. Note that the user sketch is not erased during exclusion or reset process. |
