€ 44,62
Brez DDV: € 36,88
Opis artikla
Z-Uno is the first and only easy to use developer board that allows you to create your own Z-Wave device without deep knowledge of Z-Wave protocol or programming. Z-Uno is a mix of Z-Wave home automation radio protocol power and Arduino simplicity. Being inspired by Arduino project Z-Uno inherits all concepts of easy-to-use hardware and software solutions, keeping maximum flexibility.
Z-Uno is a fully DIY product. It is made for those who are limited by existing choice of Z-Wave products and wants to extend their smart homes with more sensors and actuators: connect LEDs, buttons, switches, motors or any low voltage sensor including most of Arduino compatible sensors.
Z-Uno programming is done by writing sketch in simplified C language and loaded into Z-Uno using Arduino IDE. Many examples and comprehensive tutorials will help you to make your own project.
Being Z-Wave Plus certified device, Z-Uno is the perfect companion for you RaZberry gateway. Z-Uno is compatible with other controllers too: among them Fibaro Home Center 2/Lite, Vera Edge and Zipato Zipabox.
http://z-uno.z-wave.me/news/
Karakteristike
| Glavni krmilnik Združljivost | |
|---|---|
| eeDomus+ | Full Compatible |
| Fibaro Home Center 2 v4.160 | Not Tested |
| Fibaro Home Center Lite v.4.160 | Not Tested |
| Vera Edge / Plus / Secure | Not Tested |
| Zipabox/Zipaminicro/ZipaTile | Not Tested |
| Piper / Piper NV (v.1.7.1) | Not tested |
| Indigo | Not tested |
| jeedom | Full Compatible |
| Z-Wave.me / Z-Way / PoPP Hub v 3.2.1 | Full Compatible |
| Domoticz | Not tested |
| OpenHAB | Not tested |
| ZiHome | Not tested |
| Tech Data | |
| Power Supply | USB 5 V, external 5V or 3 V, external 7-18 V or battery (via MU-2F connector, included) |
| Attachable Loads | Defined by user: http://z-uno.z-wave.me/examples/Certified10Channels/ |
| Explorer Frames - NWI Support | Yes |
| SDK | 6.51.06 |
| Device Type | Always On Slave |
| Z-Wave Alliance Product Link | http://products.z-wavealliance.org/products/1825 |
| Procedures | |
| Inclusion | Press Service button three times |
| Exclusion | Press Service button three times |
| Factory Reset | Hold Service button for five seconds, then press Service button three times. Use this procedure only if your controller is missing or inoperable. Note that the user sketch is not erased during exclusion or reset process. |
