€ 64,99
Brez DDV: € 53,71
Opis artikla
The Eurotronic COMET Z-Wave Plus is an energy-saving controller compatible with the Z-Wave wireless standard. With this controller, the Z-Wave smart home network can be expanded with an energy-saving component. Depending on the mode, the energy saving regulator can be used as a heating thermostat or act only as an actuator when the control is deactivated.
The temperature measured by the internal sensor or the position of the valve motor can be reported to the corresponding gateway via Z-Wave (please note the compatibility with your Z-Wave gateway). Equipped with FLiRS (Frequent Listening Slave Receiver), the energy-saving controller responds to incoming commands (e.g. temperature changes) with a particularly short latency time. TECHNICAL
ESPECIFICATIONS:
- FLiRS function
- Illuminated LED display
- Individually programmable heating and saving times
- Lock with key
- Open window detection
- Vacation function
- Frost protection function
- Anti-limescale function
- Power: 2 x 1.5V LR6/Mignon/AA
- Connection: M30 x 1.5mm
- Scope of delivery: Comet Z-Wave
- Quick Start Guide, 2 LR6/Mignon/AA batteries, 3 plastic adapters (Danfoss RA, RAV, RAVL)
Karakteristike
| Glavni krmilnik Združljivost | |
|---|---|
| Fibaro HC3 Lite 5.090.V2 | |
| eeDomus+ | |
| Fibaro Home Center 2 v4.160 | |
| Fibaro Home Center Lite v.4.160 | |
| jeedom | |
| Z-Wave.me / Z-Way / PoPP Hub v 3.2.1 | |
| Domoticz | |
| OpenHAB | |
| Home Assistant | |
| Smartthings | |
| Tech Data | |
| IP Rating | |
| Power Supply | |
| Attachable Loads | |
| Z-Wave Alliance Product Link | |
| S2 Security Frame | |
| Procedures | |
| Inclusion | |
| Exclusion | |
| Factory Reset | |
| Supported Home Automation Protocols | |
| Z-Wave Plus | |
