€ 59,99
Brez DDV: € 49,58
Opis artikla
The STRIPS Comfort by Sensative is an ultra-thin sensor designed to the temperatur and the light level.
So you control the climate in your rooms and secure your furniture at the same time. The STRIPS Comfort surprises with its design as well as with its battery which has got a lifetime up to 10 years. Furthermore the strip can alert you if the temperature or the light level reaches above or below a defined value.
Features:
- Extremely thin sensor strip for temperatur and light
- For indoor and outdoor use
- Alert function for temperatur and light level
- Fixed installed battery with at least 10 years lifetime
- Operating temperatur: -20°C till +60°C
- Light sensor range: 1-64.000 LUX
- Wireless technology: Z-Wave Plus
Manual:
Karakteristike
Glavni krmilnik Združljivost | |
---|---|
eeDomus+ | Full Compatible |
Fibaro Home Center 2 v4.160 | Full Compatible |
Fibaro Home Center Lite v.4.160 | Full Compatible |
Vera Edge / Plus / Secure | Full Compatible |
Zipabox/Zipaminicro/ZipaTile | Full Compatible |
Piper / Piper NV (v.1.7.1) | Full Compatible |
Indigo | Full Compatible |
jeedom | Full Compatible |
Z-Wave.me / Z-Way / PoPP Hub v 3.2.1 | Full Compatible |
Domoticz | Full Compatible |
ZiHome | Full Compatible |
Somfy Tahoma | Full Compatible |
Home Assistant | Full Compatible |
Telldus | Full Compatible |
Tech Data | |
IP Rating | IP44 |
FLiRS | No |
Power Supply | Internal Battery |
Attachable Loads | No |
Explorer Frames - NWI Support | No |
SDK | 6.51.10 |
App Version | HW: 1 FW: 0.04:00.04 |
Device Type | Multilevel Sensor |
Z-Wave Alliance Product Link | https://products.z-wavealliance.org/products/2942 |
Procedures | |
Inclusion | Set your controller to add mode (see your controller’s manual). Follow the instruction for Wake up. A long LED blink indicates that the add/remove was successful. |
Exclusion | Set your controller to remove mode (see your controller’s manual). Follow the instruction for Wake up. A long LED blink indicates that the add/remove was successful. |
Factory Reset | You may need to reset Strips if your Z-Wave controller is missing or not responding. Follow the instructions for “Wake up”, but on the 3rd repetition, leave the magnet at the rounded edge for 10 seconds. A long LED signal indicates success. |
Wake Up | Wake up Strips manually for Z-Wave communication. Place the magnet at the rounded edge. When the LED blinks, move the magnet away. Repeat twice within 10 seconds. |